Ultrasonic tank level sensor online store from Drurylandetheatre? The Displacer level controller changes the magnetic float to a float. Displacer level transmitter uses tiny metal film strain sensing technology to measure liquid level, interface or density. Such as Fisher DLC3010 Digital Level Controller. The hydrostatic level controller works by using the measuring principle of hydrostatic pressure. Generally, a silicon pressure sensor is used to convert the measured pressure into an electrical signal. Then it is amplified by the amplifier circuit and compensated by the compensation circuit. Finally, it is output in 4-20ma or 0-10ma current mode. Sino-Inst offers over 10 Ultrasonic Liquid Level Controllers for level measurement. About 50% of these are fuel level meters, 40% is the tank level sensor.
The advantages of ultrasonic liquid level gauge are very outstanding. It is mainly reflected in the following aspects : Adopt non-contact measurement. It is not easily affected by the viscosity and density of the liquid. Of course, the ultrasonic liquid level gauge also has its own limitations and insurmountable defects. Specifically, it is mainly manifested in: There is a blind spot in the ultrasonic liquid level measurement. The dead zone is the area where the meter cannot measure. During the transmission of ultrasonic pulses, a small area near the ultrasonic transducer usually cannot receive sound waves. The blind zone where sound waves cannot be received is related to the measurement distance of ultrasonic waves. Generally speaking, the smaller the measurement distance, the smaller the blind zone. The larger the measurement distance, the larger the blind zone.
In the measurement, the ultrasonic pulse is emitted by the sensor (transducer), and the sound wave is reflected by the liquid surface and then received by the same sensor or ultrasonic receiver. Through piezoelectric crystal or magnetostrictive device into electrical signals. The distance between the sensor and the measured liquid surface is calculated by the time between the transmission and reception of sound waves. Find even more details on https://www.drurylandetheatre.com/hs-2000-ultrasonic-tank-level-sensor/.
HS-2000 External Mounted Ultrasonic Tank Level Sensor- (referred to as “external level gauge”). It adopts advanced signal processing technology and high-speed signal processing chip. It breaks through the influence of container wall thickness. Realizes the height of the liquid level in the closed container True non-contact measurement. The ultrasonic liquid level sensor (probe) is installed directly under the outer wall (bottom) of the container under test. Non-contact measurement function , Ultrasonic sensor probe is external. No need to open a hole in the container to be tested.
HS-ULC Ultrasonic Level Switch is specially used to measure the liquid level of tanks. Because it is installed on the outside of the tank, there is no need to punch holes, which is widely welcomed by customers. Of course, if your tank already has holes, you can also choose other tank level transmitters. The ultrasonic principle can also be used to measure water depth. Please refer to Portable Ultrasonic Water Depth Gauge for water depth measurement. The sensor of the external liquid level switch couples the generated high-frequency ultrasonic pulse to the container wall through the couplant. Find more details at https://www.drurylandetheatre.com/.
